AQUANOX A8830 cleans solder paste from stencil apertures in ultrasonic immersion cleaning tanks. A typical wash cycle using a 10% solution of A8830 at room temperature typically requires less than a 4-minute wash cycle and easily rinses with water, leaving no residue on stencil surfaces.  AQUANOX A8830 effectively cleans all solder paste types including water-soluble, rosin, lead-free and no-clean formulas.

AQUANOX A8830 is a mild formulation that does not damage SMT stencils and is highly effective at removing all types of un-reflowed solder pastes from fine pitch apertures. A8830 is a low-odor cleaner that can be used without issue in open-top systems. AQUANOX A8830 is environmentally friendly and is an ideal option for areas where air emissions are highly regulated with a VOC level of less than 1 gram per liter at in-use conditions.

Product Data
Application: Stencil Cleaning
Typical Process
Process: Immersion and Ultrasonic
Concentration: 10-15%
Temperature: Ambient
Rinse: Recommended
Dry: Convection / Air Knife
Product Properties
pH (10g/L): 11.1
Flash Point: None to Boiling
Boiling Point: 216°F / 102°C
Water Soluble: Soluble
VOC, @ 10% .7 g/L

NOTE: The above process parameters are recommendations based on extensive testing done in KYZEN’s application lab. Your KYZEN sales representative can assist you in optimizing your process parameters.

×
Fields marked with * are required
Product Supplement
A Representative to Contact Me
Please see comments below
×
Fields marked with * are required

Process Care Center

Improve productivity with advanced products and services that monitor, manage and control your cleaning processes.

×